LEMAN RemoteID Status LEDs and Sound Indications
LED indicators
The LEMAN RemoteID drone tracker has RED and BLUE status LEDs. The tables below specify the status indications for each LED.
The RED Status LED gives information on the tracker’s connectivity:
| • | One blink every 5 sec | Standby - tracker is powered, but no SIM card inside |
•• •• •• •• … | A burst of two blinks repeated every 5 seconds | Network Connectivity ON - normal operation |
| •••••• … | Fast blinks, 2-3 per second | Trying to attach after power-on or issues with connectivity |
The BLUE status LED gives information on the GPS status:
| • | One blink every 3 seconds | GPS ON |
| ⨯ | Off | GPS in sleep mode |
The LEMAN RemoteID drone tracker is fully operational when the RED status LED is doing two blinks (pattern •• •• •• •• •• … ) and the BLUE status LED is doing one blink every 3 seconds.
When the drone tracker is inserted to the charging station, the RED LED on the tracker gives information on the battery status:
| ⎯⎯⎯⎯⎯⎯⎯ | Continuous | Charging |
| ⨯ | Off | Full battery |
Sound and vibration indicators
On power-up, the LEMAN will vibrate once and beep 3 times with a high tone.
About 30 sec later, it will beep 2 times with a low tone, to signal that the boot of the device is finished and it is ready for normal operation. However, to be sure that it is ready for operation, please observe the status LEDs to verify the network connection and GPS acquisition.
On power off, the device will vibrate once, beep 2 times with a low tone, and power off.